The wishlist name can't be left blank
×

:

Not a valid Time
This is a required field.
DCD 5

DCD 5" Sealed Duct Puller 1/EA

DCD 40mm Sealed Duct Puller 1/EA

DCD 40mm Sealed Duct Puller 1/EA

DCD 6" Sealed Duct Puller 1/EA

$940.16
Availability: Pending Availability



SKU
DCD 00650-600
Sold Per 1 Each DCD 6" Sealed Duct Puller Product Information:

These products are designed to install polyethylene ducting using expanding jaws to grip the inside diameter of the duct while the outside diameter is prevented from stretching by a permanent outer sleeve on the puller. The outer sleeve also provides a complete seal around the ducting preventing any fluids or contaminants from entering either the duct or the pulling eye

The pulling head is manufactured from alloy steel and is designed to protect the mechanism from heavy knocks or side loads. It is also fully sealed to prevent any fluid entry

Care should be taken at all times not to exceed the yield value of the ducting since this may cause permanent deformation to the duct as well as loss to the integrity of the polyethylene

These duct pullers are installed quickly and easily and require no special tooling. A new tooth profile makes removal much easier than the earlier models

Duct wall thickness is normally designated by an SDR value. The lower the SDR value, the heavier the wall thickness. These products can be used on SDR 9 through SDR 17 ducting and Schedule 40 pipe. Part No.: 00650-600 Nominal Duct Size: 6" 3:1 Safe Working Load: 43,600 lbs. Rear Eye Capacity(SWL): 2,500 lbs. Inside Duct Diameter: Decimal: Min.: 5.063" Max.: 6.063" Millimeter: Min.: 128.6 Max.: 154.0 Outside Duct Diameter: Decimal: Max: 6.625" Millimeter: Max: 168.3 Weight: 48.00 lbs.

More Information
Alt ProductID 00650-600
Size 6"
Weight 48.000000
New Yes
Description Sold Per 1 Each DCD 6" Sealed Duct Puller Product Information:

These products are designed to install polyethylene ducting using expanding jaws to grip the inside diameter of the duct while the outside diameter is prevented from stretching by a permanent outer sleeve on the puller. The outer sleeve also provides a complete seal around the ducting preventing any fluids or contaminants from entering either the duct or the pulling eye

The pulling head is manufactured from alloy steel and is designed to protect the mechanism from heavy knocks or side loads. It is also fully sealed to prevent any fluid entry

Care should be taken at all times not to exceed the yield value of the ducting since this may cause permanent deformation to the duct as well as loss to the integrity of the polyethylene

These duct pullers are installed quickly and easily and require no special tooling. A new tooth profile makes removal much easier than the earlier models

Duct wall thickness is normally designated by an SDR value. The lower the SDR value, the heavier the wall thickness. These products can be used on SDR 9 through SDR 17 ducting and Schedule 40 pipe. Part No.: 00650-600 Nominal Duct Size: 6" 3:1 Safe Working Load: 43,600 lbs. Rear Eye Capacity(SWL): 2,500 lbs. Inside Duct Diameter: Decimal: Min.: 5.063" Max.: 6.063" Millimeter: Min.: 128.6 Max.: 154.0 Outside Duct Diameter: Decimal: Max: 6.625" Millimeter: Max: 168.3 Weight: 48.00 lbs.

ASIN B083QMZTYW