The wishlist name can't be left blank

DCD 5" 00620 Series Duct Puller 1/EA

SKU
DCD 00620-500
$661.76
Sold Per 1 Each DCD 5" 00620 Series Duct Puller Product Information:

These products are designed to grip polyethylene ducting using expanding jaws to grip the inside wall of the duct. This causes the pulling load to be spread around the circumference of the duct and allows a maximum load to be applied without damage to the ducting

Care should be taken at all times not to exceed the yield value of the ducting since this may cause permanent deformation to the duct as well as loss to the integrity of the polyethylene. On thin wall ducting, it is recommended that an outer duct sleeve be used to prevent the duct stretching during installation. A firmer and more stable grip will also be obtained when this is done. Use of a duct plugger will help to prevent mud and slurry from entering past the puller into the ducting. Duct wall thickness is normally designated by an SDR value. The lower the SDR value, the heavier the wall thickness. These products can be used on SDR 11 through SDR 17 ducting

When ordering 10 and 12 Duct Pullers, the inside diameter of the duct must be known in order to select the correct duct puller part number. Jaw sets are easily interchangeable in the 10 and 12 size pullers. Alternate jaw sets for different SDR values can be purchased separately Part No.: 00620-500 Nominal Duct Size: 5" 3:1 Safe Working Load: 25,500 lbs. Rear Eye Capacity(SWL): 4,250 lbs. Inside Duct Diameter: Decimal: Min.: 4.500" Max.: 5.000" Millimeter: Min.: 114.3 Max.: 127.0 Weight: 32.00 lbs. Duct Sleeve Part No.: 00625-500 Duct Plugger Part No.: 00630-500

More Information
Weight 36.100000
Size 5"
New No
Description Sold Per 1 Each DCD 5" 00620 Series Duct Puller Product Information:

These products are designed to grip polyethylene ducting using expanding jaws to grip the inside wall of the duct. This causes the pulling load to be spread around the circumference of the duct and allows a maximum load to be applied without damage to the ducting

Care should be taken at all times not to exceed the yield value of the ducting since this may cause permanent deformation to the duct as well as loss to the integrity of the polyethylene. On thin wall ducting, it is recommended that an outer duct sleeve be used to prevent the duct stretching during installation. A firmer and more stable grip will also be obtained when this is done. Use of a duct plugger will help to prevent mud and slurry from entering past the puller into the ducting. Duct wall thickness is normally designated by an SDR value. The lower the SDR value, the heavier the wall thickness. These products can be used on SDR 11 through SDR 17 ducting

When ordering 10 and 12 Duct Pullers, the inside diameter of the duct must be known in order to select the correct duct puller part number. Jaw sets are easily interchangeable in the 10 and 12 size pullers. Alternate jaw sets for different SDR values can be purchased separately Part No.: 00620-500 Nominal Duct Size: 5" 3:1 Safe Working Load: 25,500 lbs. Rear Eye Capacity(SWL): 4,250 lbs. Inside Duct Diameter: Decimal: Min.: 4.500" Max.: 5.000" Millimeter: Min.: 114.3 Max.: 127.0 Weight: 32.00 lbs. Duct Sleeve Part No.: 00625-500 Duct Plugger Part No.: 00630-500