The wishlist name can't be left blank
×

:

Not a valid Time
This is a required field.

DCD 1-1/2" Duct Puller 1/EA

SKU
DCD 00616-150
Pending Availability
$185.37
DCD 1-1/2" Duct Puller 1/EA is available to buy in increments of 1

Specifications:

  • Part No.: 00616-150
  • Nominal Duct Size: 1-1/2"
  • 3:1 Safe Working Load: 3,600 lbs.
  • Rear Eye Capacity(SWL): 1,100 lbs.
  • Inside Duct Diameter: SAE: Min.: 1.437" Max.: 1.812" Metric: Min.: 36.5mm Max.: 46.0mm
  • Weight: 1.50 lbs.
  • Duct Sleeve Part No.: 00625-150

Sold Per 1 Each

DCD 1-1/2" Expanding Duct Puller

Product Information:

These products are designed to install polyethylene ducting using expanding jaws to grip the inside diameter of the duct while the outside diameter is prevented from stretching by a permanent outer sleeve on the puller. The outer sleeve also provides a complete seal around the ducting preventing any fluids or contaminants from entering either the duct or the pulling eye

The pulling head is manufactured from alloy steel and is designed to protect the mechanism from heavy knocks or side loads. It is also fully sealed to prevent any fluid entry

Care should be taken at all times not to exceed the yield value of the ducting since this may cause permanent deformation to the duct as well as loss to the integrity of the polyethylene

These duct pullers are installed quickly and easily and require no special tooling. A new tooth profile makes removal much easier than the earlier models

Duct wall thickness is normally designated by an SDR value. The lower the SDR value, the heavier the wall thickness. These products can be used on SDR 9 through SDR 17 ducting and Schedule 40 pipe

More Information
Alt ProductID 00616-150
Technical Detail

Specifications:

  • Part No.: 00616-150
  • Nominal Duct Size: 1-1/2"
  • 3:1 Safe Working Load: 3,600 lbs.
  • Rear Eye Capacity(SWL): 1,100 lbs.
  • Inside Duct Diameter: SAE: Min.: 1.437" Max.: 1.812" Metric: Min.: 36.5mm Max.: 46.0mm
  • Weight: 1.50 lbs.
  • Duct Sleeve Part No.: 00625-150
Weight 1.500000
Size 1-1/2"
New Yes
SAE/Metric SAE
Description

Sold Per 1 Each

DCD 1-1/2" Expanding Duct Puller

Product Information:

These products are designed to install polyethylene ducting using expanding jaws to grip the inside diameter of the duct while the outside diameter is prevented from stretching by a permanent outer sleeve on the puller. The outer sleeve also provides a complete seal around the ducting preventing any fluids or contaminants from entering either the duct or the pulling eye

The pulling head is manufactured from alloy steel and is designed to protect the mechanism from heavy knocks or side loads. It is also fully sealed to prevent any fluid entry

Care should be taken at all times not to exceed the yield value of the ducting since this may cause permanent deformation to the duct as well as loss to the integrity of the polyethylene

These duct pullers are installed quickly and easily and require no special tooling. A new tooth profile makes removal much easier than the earlier models

Duct wall thickness is normally designated by an SDR value. The lower the SDR value, the heavier the wall thickness. These products can be used on SDR 9 through SDR 17 ducting and Schedule 40 pipe

ASIN B083VT6Y2B